15 Verbindung VS200 Scanner und VS200 Loader
15
Verbindung VS200 Scanner und VS200 Loader
15.1 Mechanical Connection VS200 scanner and VS200 loader
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
This chapter describes the mechanical connection between the VS200 scanner and
the VS200 loader.
Hex screwdriver (size 5 mm)
1. Switch the VS200 system off using the main power switch and disconnect
the system from the power supply.
2. Place the VS200 loader to the right of the VS200 scanner, leaving a small
gap between them.
3. Remove the handles from the right side of the VS200 scanner and from the
left side of the VS200 loader.
4. Remove the jumper plug on the VS200 scanner.
5. Plug the VS200 loader’s control cable into the port on the VS200 scanner
where the terminator was. The plug should point towards the back.
- 75 -
Instructions for use
OLYMPUS VS200 System
