12. Use two persons to lift the loader onto a very stable table to the right side of
the VS200 scanner. The center of gravity is at the right backside of the sys-
tem.
13. Remove the handles and keep them as they might be needed in the
future.
ATTENTION
The system should not be repositioned by the end user. If the system has to be
repositioned an Olympus sales representative has to be contacted first.
9.3.1
VS200 Trays
1. Unbox the VS200 trays carefully and handle them with care. Avoid bending
of a tray at any time.
2. Put the trays aside for later use.
9.3.2
PC and monitor
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
1. Take the PC out of it's cardboard packaging.
Inside the PC cardboard packaging you find the mouse and keyboard
as well.
2. Take the monitor out of it's cardboard packaging and put it onto the table.
All necessary cabels are inside the cardboard packaging.
9.4
VS200 loader transportation locks
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
This chapter describes how to remove the transportation locks from the VS200
loader after shipping.
- 32 -
Instructions for use
9 Unboxing
OLYMPUS VS200 System
