36
921468007_09_010
477, BS-470, BS-471, BS-475). The bottom line contains the unique address of the added device
(in our case 0300010F).
4. After a few seconds the installation screen reappears and we can add other devices if needed in
the same way. After inserting a device, a 10-second interval occurs during which no other device
can be identified.
5. If 32 devices have already been installed and try to add another, 4 long beeps will be heard. No
other devices can be installed.
6. By pressing the
" #
ESC
"
button, the installation procedure stops and we get back to "Wireless
Network" menu.
NOTE: For every change we make in the wireless zone menu and during the detection of extensions,
it takes time to update the wireless system data. During this process, when we try to enter a menu, a
message is displayed. When the process is complete, we can again use the menus.
Installing wireless network devices with your PC and the BS-477 Wireless Keyboard
In this case, the network installation should be done by PC-468 software. For this reason, there is a
USB connector on the BS-468/A too. The user should follow the following steps.
1. Plug the USB cable on the BS-468/A panel.
2. Open the PC-468 software and press "Scan keypads".
3. Press "Scan extensions".
4. Start "Network Setup" from the wireless tab.
As far as processes 3 and 4 are in progress, the BS-477 should not have its batteries. When the bat-
teries are loaded, the panel will recognize it and install it into its network as well as any other wireless
devices assigned to the panel. The corresponding indicator on the PC program will also be updated.
When all of the above steps have been completed, the rest of the wireless network settings can be
executed normally by the BS-477.
Wireless network installation without keyboard and PC
The procedure is simple and is realized via BT1 button of the BS-479 expansion card. The process is
divided into 2 parts, the first one concerns the device detection and the second concerns the installa-
tion of a wireless keypad. When the BS-477 wireless keypad is installed, the installation of other de-
vices can be completed by this keyboard
’s menu. To process the procedure focus on BT1 button as
well as LED LD4 (green) of the BS-479 card. The total process of inserting a wireless keypad into the
network lasts approximately 2 minutes. It is noted that if another device is currently in technician
menu, the below procedure cannot take place.
INSTALLATION PROCEDURE STEPS
First, BS-468/A should detect the BS-479 extension. It will also search in general for all connected
devices, extensions and wired keyboards. The batteries, of the wireless keypad that will be inserted
into zone 25, should not be installed and the tamper switch must not be pressed. The procedure is the
following:
1. Power on the panel and wait for 30 seconds to initialize. At this stage, LD4 (green) is off.
2. Press the BT1 button for about 3 seconds until the LD4 lights up. Then release the button.
3. Wait about 60 seconds until LD4 goes out, indicating that devices detection has been com-
pleted.
4. Install the batteries to the keypad device. The panel will detect it and insert the device to the
network.At the same time LD4 will turn off.
5. Wait 15 seconds for the LCD and the LEDs of the wireless keypad. The procedure is now
complete and the rest of devices will be installed by this keypad’s technician menu.
6. End of procedure.
Содержание BS-468/A
Страница 1: ...BURGLAR ALARM PANEL BS 468 A...
