Date
9/7/2018
File
BSR-2114/MAR
Document Number
921211401_09_002
Page
64 από 74
64
5.4.2
Setup - Sirens
If Siren configuration is selected then a window is opened that permits us to select the siren that is to be configured. Select
the required siren by using the
«UP»
and
«DOWN»
keys.
Figure 5-12 shows a typical siren configuration screen.
Figure 5-13
Siren configuration
In order to change the activation method, move the arrow to point to the setting
«ACTIVATION METHOD»
and press the
«ENTER»
key
.
A window will open with the following selections :
ACTIVATION WITH AN ALARM
: The siren is activated by a general alarm.
ACTIVATION FROM ZONES
: The siren is activated by a zone or a function.
Select the required option using the
«UP»
and
«DOWN»
keys and press
«ENTER»
to confirm the selection.
Additionally we can change :
NAME
: The name of the siren.
STATUS
: If the siren is enabled or disabled.
SILENCE ENABLED
: If
YES
is selected the then siren or output with silence with a command
«SILENCE SIRENS» .
If
we select
NO
then they will not silence when the SILENCE SIREN key is pressed.
DELAY BEFORE ACTIVATION
: Delay before activation in seconds (1-240).
MODE OF ACTIVATION
: Change the method of activation (0 to 4).
ZONE (1-96) FUNCTION (97-150)
: The siren or output are activated by a zone or a function or by a general alarm (if
0 is selected).
Press the
«ENTER»
key to accept the changes or the
«ESC»
to cancel.
Finally to save all the changes that have been made to the siren configuration select
«TO STORE CHANGES PRESS ENTER»
and
press the
«ENTER»
key.
