Olivetti 3D S2, Руководство по обслуживанию

Страница: 77 / 112

Y118040-3 Service Manual 4-35
During reassembly pay particular attention to the following points.
8. The setscrew of the gear must be inserted into the flat side of the shaft ( 4 ). Align the gear with the shaft
head ( 5 ) and tighten the setscrew.
Figure 4-57
10. With the hex screw ( 6 ) torque tightened, position the bowden with the holes for the filament centred on
each other (on the same vertical axis).
Figure 4-58
11. Torque tighten the hex screw ( 7 ) against the thrust spring ( 8 ) of the feeder assy wheel ( 9 ). Give the screw
( 7 ) a further half turn and then tighten the (9.5 mm) nut ( 10 ).
Figure 4-59
4
5
6
7
9
10
8