Olivetti 3D S2, Руководство по обслуживанию

Страница: 37 / 112

Y118040-3 Service Manual 3-15
WARNING: on the first manual extrusion you may find residues of previously printed material; this is
completely normal because the machine is subjected to testing before being packaged.
NOTE: should the filament not flow out smoothly, repeat the previous steps because either the
operating temperature is incorrect for the type of filament loaded or a duct must still be obstructed with
Teflon tape.
PRINTING A TEST PIECE
On the SD Card supplied in the package there is a file that can be used for running a printing test, so that you
can gain confidence using the printer.
To ensure good bonding between the first layer printed and the printing plate, spray a thin adhesive solution
on the plate, as shown in the video clip
”Soft glue application method”
. To print the test piece proceed as
described below:
1. Insert the SD Card supplied in the package into the slot at the front of the printer.

Select Print from SD to access the file manager.

Select the file to print (for example: Test cube.gcode) by rotating the jog dialer and pressing to
confirm.
Figure 3-30 Command sequence for printing a piece
2. Launch printing. The printer carries out the following procedures:

Homing of all axes.

Heating of hot-end and plate (if necessary) until the temperature required is reached.

Extrusion of a length of material for loading into the extrusion chamber.

Movement in the printing area and start of printing procedure for each successive layer.

On terminating printing, the machine executes the Homing procedure for the carriage and switches off
the heaters to allow the extruders to return to ambient temperature.
All printing processes can be monitored from the printer display’s Start screen.
NOTE
: The printing format supported by the Olivetti 3D S2 printer has the extension .gcode.