Reference/System
Series
TOYOTA Tacoma
Procedure
Issue A 09/15/15
Page | 16
8. Quick-Sync Wiring Harness install
a. Run Quick-Sync Harness and install ground
1. Remove the dead pedal in the driver-side kick
panel area. Using the panel tool, wedge this
piece out of place and pull directly toward you.
(Fig. 8-1)
2. Remove the driver-side threshold and driver-
side kick panel by unscrewing the black locking
tab.
(Fig. 8-2)
3. Continue routing the Quick-Sync Wiring
Harness radio connects and power wire towards
the driver sidekick panel area. Use cable ties as
necessary and leave wires in kick panel
fl
oor area
for time being.
(Fig. 8-3)
4. Run the Quick-Sync Harness’ ampli
fi
er
connectors and ground under the carpet opening
from the front driver’s side threshold to the
opening used by the factory wiring that connects
under the seat.
(Fig. 8-4, 8-5)
Fig. 8-1
Fig. 8-2
Fig. 8-3
Fig. 8-4
Panel tool
Cable ties
