Reference/System
Series
TOYOTA Tacoma
Procedure
Issue A 09/15/15
Page | 11
f. Apply pressure to the panel pushing towards the
passenger side to disengage the locking clips. The
bottom-locking clip of the panel may require a panel
tool to disengage. Position the tool between the tab
and the frame of the vehicle and pry open.
(Fig. 5-7)
g. You’ll need just enough room to run the umbilical
cable to the drivers side of the passenger side
bench. Tuck the umbilical along the side/rear panel
using cable ties as necessary for a clean run.
(Fig. 5-8)
h. Continue to run the length of the wire alongside
the drivers-side threshold towards the front of
the truck. Lock plastic clips after running the wire
through. Once getting to the seat belt trim lay
the subwoofer cable connector for the time being.
(Fig. 5-9)
i. Position the rear storage panel back in the vehicle
running the sub connector through with 3 inches
of slack remaining once panel is in rested position.
Reinstall rear storage panel ensuring all clips are
engage and hardware.
(Fig. 5-10)
Fig. 5-7
Fig. 5-8
Fig. 5-9
Fig. 5-10
Socket 10mm
