Oce VarioStream 7000 SINGLE, Руководство по эксплуатации

Страница: 267 / 384

7.3.3 Replacing the cleaning brush
A29246-X20-X-4-7680 / fa701.fm
267
Install cleaning brush
Caution
There can be a high build-up of static charge when vacuuming the toner spill.
Always use an industrial vacuum cleaner with a grounded suction tube, rubber
nozzle and filter set for fine dust. For larger quantities of toner spill (e. g. full bottle),
the industrial vacuum cleaner must be explosion-proof.
11. Clean the front outside insertion area with the vacuum cleaner.
Caution
Observe the safety directives before installing the cleaning brush( see section 7.3.3
Replacing the cleaning brush, page 263) .
Proceed as follows:
1. Hold the new brush at the end that has no slit.
2. Insert the new cleaning brush into the
opening, push to the back of the casing
and turn slightly to click the woodruff
key on the rear axis into the slot on the
cleaning brush (verify that the cleaning
brush rotates).
3. Check that the cleaning brush turns with its drive. If the cleaning brush is correctly
inserted, and is turned slightly, you will feel the flywheel mass of the drive.
4. Hold cleaning brush in this position.
5. Insert the cover cap insert taper into the front brush opening and push as far as the
system casing. The cover cap must be flush everywhere.
1 of 2
Proceed as follows:
4 of 4