Oce VarioPrint 2090, Руководство по эксплуатации функций

Страница: 81 / 128

Copy jobs 77
Correct the settings for a copy job
Introduction
You can define or change the settings of a copy job until you press the start key
or the set-build key . When you create a copy job, you open the job
editor. There you select the required job settings. Use the correction key to
correct the settings.
How to correct the quantity setting for a copy job
1
Press the correction key once to reset the quantity setting (number of
prints).
2
Use the numeric keys to enter a new value.
3
Press the start key to send the job to the job queue.
Note:
If the number of prints is 1, you can not reset the quantity setting to
default. In this case, the job settings are set to default when you press the
correction key once.
How to correct the settings in the 4 copy job sections
1
Press the correction key two times to reset the values in the 4 sections of
the job editor. This action changes all the copy job settings back to the default
value.
2
Use the function keys above the operator panel to access the 4 copy job
sections.
3
Use the function keys below the operator panel to select the required settings.
4
Press the start key to send the job to the job queue.