Oce CS9090, Руководство пользователя

Страница: 34 / 177

Chapter 3: Setting up the unit
AP-75036 - Revision 1.3 – 20/03/06 34 User’s Guide CS9000 series
3.3.3 Adjusting the position of the main unit to the stand
After installation of the main unit onto the stand, please check if there is no gap between the printer body and
the stand.
When you notice that there is a gap between the printer body and the stand, please follow the instructions
mentioned below to minimize this gap.
Notes
Please find enclosed three types of spacers.
•
5 pieces : 0.3 mm spacer
•
5 pieces : 0.5 mm spacer
•
5 pieces : 1.0 mm spacer
Procedure:
Step 1 :
Decide if the stand spacers are necessary, using the table below.
IF … THEN …
there is a gap between the stand and
the main unit. stand spacers are necessary, continue
with the procedure
there is NO gap between the stand and
the main unit. stand spacers are not necessary, stop
this procedure
Step 2 :
Loosen (don not remove!) the screws fixing the stand to the unit.
Step 3 :
Insert a stand spacer between the stand and the printer body.
Step 4 :
Fully insert the spacer between the stand and the printer body.
Step 5 :
Tighten the screw.