Oce Arizona 600, Руководство пользователя

Страница: 55 / 148

Print & Go Media Installation
12/9/04 3-27
Use the +/- buttons to set the feed adjustment from -30 to +30. The default value
is 0.
The feed adjustment feature enables the adjustment of media stepping to
compensate for variation in media lots and environmental factors. The plus
direction lengthens each media step. The minus direction shortens each media step.
9. Press ACCEPT. You then see:
MEDIA MENU
hor margins: (0.2" - 4.0")
Use the +/- buttons to select the required horizontal margin value for a job.
10. Press ACCEPT. You then see:
MEDIA MENU
ver margins: (0.2" - 4.0")
Use the +/- buttons to select the required vertical margin value for a job.
11. Press ACCEPT. You then see:
MEDIA MENU
Halogen Lamps maximum power: (min, low, medium, max)
Use the +/- buttons to select the required power.
The default value is max.
The high heat from the flying IR unit can cause some media to wrinkle at the
beginning of a print. The halogen lamps maximum power setting enables the
operator to lower the temperature of the flying IR unit to possibly alleviate the
wrinkling.
12. Press ACCEPT. You then see:
WRITING GAP
“Other” head gap: optimal/wide
This option is only selectable during the Load Media process. Use the +/- buttons
to set optimal or wide. The default is
optimal .
The WRITING GAP WIDE feature sets the print carriage at its maximum height
to accommodate media that may have surface wrinkles. They can lead to carriage
strikes, which may result in a ruined print and/or potential print-head damage. For
additional information, see Appendix C on page C-1.
13. Press ACCEPT. You then see:
Sizing media
please wai
t
The printer sizes the media. If an error occurs, check the alignments along the
media path from the supply to the take-up core.