Oce Arizona 600, Руководство пользователя

Страница: 46 / 148

Océ | Media System
3-18
• Positioning of the Print & Go external media take-up unit (EMTU) square to
the front of the Arizona 600 printer
Inexact installation may result in media encoder errors, the misreading of the media width,
media rippling and/or head strikes.
3.4.1
Installing Supply Media
Océ Display Graphics Systems recommends cleaning the media drive roller after each roll
of media (see Figure 3-11 on page 3-9 and "Media Drive Roller" on page 5-3).
Océ Display Graphics Systems recommends cleaning the Print & Go drive roll after each
roll of media (see Figure 3-16 on page 3-19 and "Media Drive Roller" on page 5-3).
Follow the steps below to install a new supply media roll:
1. Install the supply media on the mandrel (see Figure 3-3 on page 3-3), ensuring that
the media is centered (see Figure 3-4 on page 3-4), and secure the locking hubs.
2. Lower the mandrel assembly support arms on both sides of the frame and place the
mandrel/media assembly into the machine (see Figure 3-5 on page 3-5). Make sure the
mandrel is seated properly on the gear and steel rollers (see Figure 3-6 on page 3-6)
.
3. Lock the mandrel on both sides of the frame.
4. Gently close the rear door completely.
3.4.2
Loading New Supply Roll
Follow the steps below for loading a new supply media roll:
1. Press the Load Media button. You then see:
Load Media
new supply roll?
2. Press ACCEPT. You then see:
Use +/- keys, attach
takeup, press ACCEPT
3. Feed the media over the supply dancer and into the vacuum platen area. To keep the
media from falling back, gently feed the media down between the back wall and the
supply dancer assembly (see Figure 3-9 on page 3-8).
4. Install the Print & Go drive roll and the pinch roller bar into the printer.
5. If not already open, gently open the top door completely, and pull the pinch roller
handle to disengage the rollers (see Figure 3-10 on page 3-9).