Objet Eden260, Руководство пользователя

Страница: 79 / 122

DOC-00260 Rev. A1
7–3
Eden260 User Guide
Figure 7-2: Eden260 interface
Loading Model and Support Cartridges
The Eden260 printer uses one cartridge of model material and one cartridge
of support material, each weighing 2 kilograms when full. A graphical
representation of the cartridges and their current weight appears in the
Eden interface.
To load model and support cartridges:
1. On the front of the Eden printer (see figure 7 ‐ 1), push the door of the
printing ‐ materials compartment to release and open it.
2. If you are replacing a cartridge, grasp its handle and pull the cartridge
out, taking care not to twist or turn it.
3. Insert model and support cartridges in their
respective drawers—the
model cartridge on the right, and the support cartridge on the left.
(Note that the cartridges only fit into their correct drawers.)
You should feel some resistance, as a needle pierces the cartridge.
4. Check the Eden interface to make sure that the new cartridge is
detected and that its weight is displayed (see figure 7 ‐ 2).
5. Close the printing ‐ materials compartment door.
Printer mode
Model material
cartridge
Display
selection
buttons
Pause button
Online/offline
button
Support
material
cartridge
Current activity
Stop button
Screen-menu
selection
Eden installations utilize one monitor for displaying both the computer
running Objet Studio / Job Manager and the computer installed inside the
Eden printer. Make sure that the KVM (keyboard-video-mouse) switch is in
the correct position so that the Eden printer interface is displayed.
If you need to replace the model material currently installed with another
type, see “Changing the Model Material” on page 7-
8
. Otherwise, make
sure to replace the model cartridge with one containing the same type of
material.