Objet Eden260, Руководство пользователя

Страница: 116 / 122

Operating & Maintaining the Eden 3-D Printer
7–40
DOC-00260 Rev. A1
To replace the waste container:
1. Locate the waste compartment under the Eden printer (see figure 7 ‐ 1
on page 7 ‐ 2).
2. Remove the two screw ‐ knobs securing the waste compartment panel,
and remove the panel.
Figure 7-68:Waste container under the printer
3. Carefully slide out the waste container, removing it from the printer.
Figure 7-69:Waste container removed from the printer
4. Place the new waste container next to the full container.
5. Unscrew the cap securing the waste drain tube and connect it to the
new container.
6. Close the full container with a sealing cap.
7. Close the new waste ‐ container box.
8. Position the waste container under the Eden printer, on the load cells.
Note: Make sure that the waste drain tube is not crimped and that it is not
pinched by the container.
9. Close the waste compartment.
Dispose of the full waste container in accordance with environmental and
safety requirements.