Press enter. Then, run the command:
sf write 0x90000000 0x0 0x100000
9. Now again type “loady” on the console, press enter, go to File -> Transfer -> YMODEM -> send and select the “ppa.itb”
file and click on “Open”.
10. Now run the following commands on the console:
sf erase 0x400000 0x100000
Press enter. Then run:
sf write 0x90000000 0x400000 0x100000
11. Now again type “loady” on the console, press enter, go to File -> Transfer -> YMODEM -> send and select the
“fsl_fman_ucode_ls1043_r1.1_106_4_18.bin” file and click on “Open”.
12. Now write the following commands on the console:
sf erase 0x900000 0x100000
Press enter. Then run:
sf write 0x90000000 0x900000 0x100000
13. The size of the kernel image is huge and it is recommended to flash it via Ethernet port only.
14. Give a hard reset to the LS1043A by pressing the LS-RST button on MPC-LS VNP EVB.
15. Stop the down counter by pressing enter to access the U-Boot console.
16. To flash the Linux image, the user needs to follow the step 8e in the section
Flash images from u-boot console via
ethernet port
.
NXP Semiconductors
How to flash the board or perform board recovery
MPC-LS Vehicle Network Processing Evaluation Board User Manual, Rev. 0, Feb 2019
User's Guide
86 / 107