NXP Semiconductors MC9S12VRP64, Руководство владельца

Страница: 208 / 555

S12S Debug Module (S12DBGV2)
MC9S12VRP Family Reference Manual Rev. 1.3
208 NXP Semiconductors
6.3.2.7.4 Debug Match Flag Register (DBGMFR)
Read: If COMRV[1:0] = 11
Write: Never
DBGMFR is visible at 0x0027 only with COMRV[1:0] = 11. It features 3 flag bits each mapped directly
to a channel. Should a match occur on the channel during the debug session, then the corresponding flag
is set and remains set until the next time the module is armed by writing to the ARM bit. Thus the contents
are retained after a debug session for evaluation purposes. These flags cannot be cleared by software, they
are cleared only when arming the module. A set flag does not inhibit the setting of other flags. Once a flag
is set, further comparator matches on the same channel in the same session have no affect on that flag.
6.3.2.8 Comparator Register Descriptions
Each comparator has a bank of registers that are visible through an 8-byte window in the DBG module
register address map. Comparator A consists of 8 register bytes (3 address bus compare registers, two data
bus compare registers, two data bus mask registers and a control register). Comparator B consists of four
register bytes (three address bus compare registers and a control register). Comparator C consists of four
register bytes (three address bus compare registers and a control register).
Each set of comparator registers can be accessed using the COMRV bits in the DBGC1 register.
Unimplemented registers (e.g. Comparator B data bus and data bus masking) read as zero and cannot be
written. The control register for comparator B differs from those of comparators A and C.
6.3.2.8.1 Debug Comparator Control Register (DBGXCTL)
The contents of this register bits 7 and 6 differ depending upon which comparator registers are visible in
the 8-byte window of the DBG module register address map.
Address: 0x0027
7 6 5 4 3 2 1 0
R 0 0 0 0 0 MC2 MC1 MC0
W
Reset 0 0 0 0 0 0 0 0
= Unimplemented or Reserved
Figure 6-12. Debug Match Flag Register (DBGMFR)
Table 6-21. Comparator Register Layout
0x0028 CONTROL Read/Write Comparators A,B and C
0x0029 ADDRESS HIGH Read/Write Comparators A,B and C
0x002A ADDRESS MEDIUM Read/Write Comparators A,B and C
0x002B ADDRESS LOW Read/Write Comparators A,B and C
0x002C DATA HIGH COMPARATOR Read/Write Comparator A only
0x002D DATA LOW COMPARATOR Read/Write Comparator A only
0x002E DATA HIGH MASK Read/Write Comparator A only
0x002F DATA LOW MASK Read/Write Comparator A only