Connectivity Test
MC1322x SMAC Demonstration Application User’s Guide, Rev. 1.3
3-2
Freescale Semiconductor
Figure 3-1. Selecting the Application Mode
The functionality of the application could vary according with the selected board. Boards with the serial
port and push buttons support both interfaces, however for boards without serial port or without push
buttons only one interface is possible.
The following sections describe using the serial interface.
3.1
Loading the Connectivity Application
Prior to loading the Connectivity application, the Connectivity Test application must be generated using
BeeKit using the steps shown in
Chapter 1, “Generating an SMAC Application and Port Configuration”
:
1. Open the
[Solution Name].eww
file as shown in
Figure 3-2
.
2. Select Connectivity Test and load this application into two boards as shown in
Section 1.1,
“Loading Applications Into a Board Using the JTAG J-Link ARM Debugger”
.
Figure 3-2. My Solution EWW File Location
Press SW1
Channel
Test
Bulk Capacitor
Fine Tune
Press SW1
Initial State
Reset
Power
Press SW1
Press SW1
Press SW1
Coarse Tune
Press SW1
Channel
Test
Bulk Capacitor
Fine Tune
Press SW1
Initial State
Reset
Power
Press SW1
Press SW1
Press SW1
Coarse Tune