Nussbaum HL 2.30 NT, Инструкция по эксплуатации и документация

Страница: 34 / 54

Operating instruction and documentation
HL 2.30 NT/ HL 2.40 NT
- 34 -
MINI-MAX lifting arm
Clean the Mini-Max in regularly interval with air
pressure. That is a reason-prerequisite for a trouble-
free function. In case of a strong contamination, a
cleaning is to be enforced.
After the cleaning, lubricate the surfaces (for
example: the bolt) with a oil.
1 Blow out the bolts with air pressure. Test the roll
on wear.
2 Check the safety screws. (The screw is only
easily fastened and additional fastened with
adhesive => Loctite
The screw cannot be put on solidly, otherwise
the smooth running of the Mini-Max
mechanisms is no longer guaranteed
3 Clean the surface and spray it.
4 Check the safety sheet.
monthly
Check that all screws and bolts are fasten correctly
with torque (turning moments, see the list)
min. once in a
year
Check all welded joints for cracks on the automotive-lift.
If any cracks are found on the lift cease use
immediately. Switch-off and secure the main switch
(lock) and call the service partner.
min. once in a
year
Check the varnish:
Damage to external surfaces, must be immediately
repaired.
If theses repairs are not made immediately, permanent
damage to the powder-coated surface may result.
Repair and clean damaged areas with an abrasive
paper (grain 120). After this is complete, use a suitable
paint (observe the RAL Number).
Check the zinc surface and repair it with a suitable
tool. Use abrasive paper (grain 280).
White rust can result from moisture laying in certain
areas for long periods of time. Poor aerating can also
result in rust formation.
Rust may result from mechanical damage, wear,
aggressive sediments (de-icing salt, liquids) or
insufficient cleaning.
Repair and clean these areas with abrasive paper
(grain 280).
After this is complete, use a suitable paint (observe the
RAL Number).
min. once in a
year