Nussbaum HL 2.30 NT, Инструкция по эксплуатации и документация

Страница: 29 / 54

Operating instruction and documentation
HL 2.30 NT/ HL 2.40 NT
- 29 -
Pic 3: Press the rear lever to unlock the pads.
• Examine the locking device of the arms. They must be locked before raising the vehicle
with the lift.
• After every lowering of the vehicle in the lowest position, examine the safe position of the
lifting arms under the vehicle. If necessary adjust it again.
• Control the dangerous places of the lift and be sure that there are no objects or people in
the immediate area of the lift or on the lift.
5.2 Lifting the vehicle
• Raise the lift until the wheels are free. Press the lever forward => „lifting“ (see pic 4)
• If the wheels are free, stop the lifting procedure and check the sit of the pads again.
Check also the locking system of the lifting arms. They must locked if the lift was raised.
Otherwise, lower the lift into the lowest position and position the vehicle once again.
• Every time, if the vehicle is lowered into the lowest position, the position of the arms, pads
under the vehicle has to be checked before next lifting.
• Control the dangerous places of the lift and be sure that there are no objects or people in
the immediate area of the lift or on the lift.
• Raise the vehicle on the working height.
Check the pads under the vehicle again, otherwise the vehicle can fall down.
Check the locking device of the arms. They must locked if the lift was raised.
pic 4: Operating unit
Main switch
Energy set optional
Lifting => press the lever in front
Lowering => pull the lever back
Operating lever
similar to Figure