Nussbaum HL 2.30 NT, Инструкция по эксплуатации и документация

Страница: 38 / 54

Operating instruction and documentation
HL 2.30 NT/ HL 2.40 NT
- 38 -
to the next pages (Dowels without tiles, floor pavement). If the ground is covered with floor
tiles, the dowels have to be chosen according to the next pages. (Dowels with tiles, floor
pavement). Observe the table of FISCHER Dowel manufacturer, too.
• Check the lining up of the columns with spirit level.
• If necessary put thin metal sheets between the base plate and the floor until the lift is in the
correct vertical position and the contact between the base plate and the floor is available.
• Tighten the dowels with the dynamometric key. Observe the regulations of the dowel
manufacturer.
Each dowel must be tightened with the demanded torque. Otherwise the normal function
of the lift can not guaranteed.
8.1.2 Initial filling
• After the installation and connection of the hydraulic and electric lines, put oil in the tank.
• Loosen the cover of the hydraulic unit and remove .
• Öleinfüllöffnung lösen und abnehmen.
• Pour in 10 Liter (oil quality 32 centristoke).
• Raise the lift approx 1000mm.
• Install the lifting arms and secure it wit he safety rings.
• Push the operating lever and raise the lift into the highest end position..
• Hold the operating lever approx 2-3 sec. until the oil flows with the over flow procedure back in
to the tank.
• Lower the into the lowest position. Pull the lever.
• After that put oil in the tank again. Oil level approx. 25mm under the opening.
•
Den Öltank nicht bis Oberkante befüllen da sonst beim senken die Ölrücklaufleitung Öl aus
dem Tank ziehen kann und danach beim die Hubgeschwindigkeit im oberen Bereich extrem
verlangsamt.
Öleinfüllöffnung
Operating lever