Nugen S10KS, Руководство по техническому обслуживанию оператора, Страница: 55 / 64

OPERATOR & MAINTENANCE MANUAL
PAGE ‐ 51
5.6 Stopping Generator Under Manual Operation Mode
1. Turn off every RCD/circuit breaker .
2. Turn the Main Isolator (17) , Circuit Breaker (15) , RCD/MCBs (18 , 19 and 20) , to
the “OFF” position.
3. Press the Stop button (6).
4. Allow the engine to remain idle for approximately one minute to cool down.
5. Turn off the Master Control Switch (9).
6. Open the side access door and turn off the Battery Isolator Switch , then close
the door.
5.7 Stopping Generator Under Automatic Operation Mode
If the mains supply returns and the generator does not stop running, follow the steps
listed below:

Turn every switch and circuit breaker on the load to “OFF” position.

Turn off the Master Control Switch (9) .

Open the side access door and turn off the engine battery switch, then close the
door.
5.8 Shutting Down Genset
The generator is equipped with an automatic shutdown feature. The LCD will display
the fault.
Warning:
In the event of a shutdown alarm, turn off the engine. Generator must be repaired by
certified or fully trained personnel according to the troubleshooting guidelines (see
6.7).