Nugen S10KS, Руководство по техническому обслуживанию оператора

Страница: 42 / 64

OPERATOR & MAINTENANCE MANUAL
PAGE ‐ 38
Room Location

A separate building located on the site away from the main building is the most
desirable.

Maintain the building at a satisfactory temperature

Ensure the generator is installed in a way that it will not compromise reliability from
any emergency loads.
Note
The generator can be used at temperatures between ‐ 15 to 50°C, An ambient temperature
that is outside these temperatures will cause damage to the equipment, when the
temperature is too low, the metal will become very weak; when the temperature is too high,
the engine temperature may rise to a point where damage is caused to the engine and other
components such as piston rings. In order to protect the engine, when the ambient
temperature is around 50°C, or close to ‐ 15°C, the equipment load must be reduced or
engine life may be compromised.
4.7 MECHANICAL CONNECTIONS
After considering all applicable codes and laws and finding a suitable location for the
generator set, the installer should consider the mechanical connections that will be
necessary to make during installation. The four (4) systems that could require mechanical
connections are the following:

Fuel system

Lubrication system

Exhaust system

Ventilation and cooling system
4.7.1 Fuel system
The fuel system feeds fuel from the fuel tank to the combustion chamber. It’s an important
part of engine.
The general fuel system of diesel engine is shown in the diagram below:
WARNING:
The floor foundation load ‐ carrying capacity must be checked and must not exceed
the weight of the generator and its associated equipment.