43
Display Name
Content
H09
Work shortage timer
Initial value: 10.0 (second)
Set range:
1.0~120.0seconds
Set the time of the timer that detects the work shortage. When the signal continues for
a set duration, the work shortage signal is set. The logic with which the timer works
depends on H00, and the timer works when the input selected with H08 during driving
(output ON) is Low (the reverse-operation is also possible by H00).
In case time is up,
noP is displayed as work shortage signal on LED, and signal is output between
C2-EM terminals (in case selected with J12).
H10
Work shortage reset timer
Initial value: 1.0 (second)
Set range:
0.1~30.0seconds
Set the time of the timer that resets the work shortage signal. When the signal
continues for a set duration, the work shortage signal (timer) is reset. The logic with
which the timer works depends on H00, and is the same operation as the OFF delay
timer (the work shortage signal is reset).
noP display goes off with reset, and signal output between C”-EM terminals also goes
OFF.
H11
Impossible of choice
This function cannot be used.
H12
Frequency data of speed 1
Initial value: 70.0(Hz)
In case of multi-speed driving, it is an area memorizing frequency data of speed 1.
Setting range: 30.0-200.0Hz
【
30.0
～
250.0Hz
】
*1
H13
Voltage data of speed 1
Initial value: 100(V)
In case of multi-speed driving, it is an area memorizing voltage data of speed 1.
Setting range: 0-200V
H14
Frequency data of speed 2
Initial value: 70.0(Hz)
In case of multi-speed driving, it is an area memorizing frequency data of speed 2.
Setting range: 30.0-200.0Hz
【
30.0
～
250.0Hz
】
*1
H15
Voltage data of speed 2
Initial value: 100(V)
In case of multi-speed driving, it is an area memorizing voltage data of speed 2.
Setting range: 0-200V
H16
Frequency data of speed 3
Initial value: 70.0(Hz)
In case of multi-speed driving, it is an area memorizing frequency data of speed 3.
Setting range: 30.0-200.0Hz
【
30.0
～
250.0Hz
】
*1
H17
Voltage data of speed 3
Initial value: 100(V)
In case of multi-speed driving, it is an area memorizing voltage data of speed 3.
Setting range: 0-200V
＊１
Value in
【 】
is for the case J11 carrier frequency is set “0:20kHz”.
