24
(1) Specification check and preparation of driving
Please check again whether neither the form, the specification
nor the power-supply voltage of the controller are wrong before
turning on power.
①
The form etc. is displayed on the controller operation side.
②
Please make the speed adjustment switch "0" (Turn
completely counterclockwise).
The adjustment of items of the above-mentioned
②
and the
following (4) and (5) is unnecessary for pre-adjusted cases
such as purchase of finished products.
(2) Power supply ON
①
Please make the power switch "ON", and confirm lighting or
blinking of LED on the operation panel. When the power
supply is ON, it turns to the normal display after soft version
was displayed for about two seconds. Please note that no
operation is accepted during the display of version
information.
When external control input terminal is short-circuited (when the
function J02 is under standard setting, it becomes operation
command) , operation starts and RUN pilot lamp lights up, and
LED changes from blinking to lighting condition.
When operation is at stop, LED becomes blinking and RUN
pilot lamp turns off.
While power supply is ON, the cooling fan is always rotating.
(3) Check of function setting content
①
It changes into the function setting mode if the function key is pressed for
two seconds or more. As J or H is displayed, select the function group that
you want to change with the UP/DN key and enter it with the data key.
When function
№
is displayed, select function
№
to be confirmed with the
UP/DN key. Here, present data is displayed when the data key is pressed,
then confirm a set content. Please refer to P.34-44 for the confirmation of
the concrete content and details of the setting method. Please return to
the normal screen pressing the function key twice when the confirmation
ends. The display automatically returns to the normal screen when the
non-operating state continues for 20 seconds.
②
There are some functions which prohibit the data change during driving.
Moreover, please note that the controller might not operate when the
setting is mistaken. (Refer to P.36-37.)
OR
Adjustment has done.
Caution
Confirm certainly the setting of the
function
b
efore driving. When the
setting is mistaken, the magnet may
burn.
Caution
Turn neither power on/off switch nor the
power supply on and off frequently. The
controller may break down.
SPEED
SPEED
Normal screen
Function group display
ＦＵＮＣ
ＲＥＳＥＴ
Function No. display
OFF
ON
O
I
First figure b is model
code and second to
forth figures show
version information.
When knob is
fully turned to
left.
