27
④
Please press the data key twice and return to the voltage display
when the adjustment ends.
Fast-forward operation of frequency
When you want to change the frequency to a large degree, usage of the fast-forward operation makes the
frequency change in a short time possible. But, please make the change while the parts feeder is vibrating,
referring to (A)-2
of the previous page for the final minor frequency adjustment.
＜
Operating method
＞
①
Stop the driving of the controller.
In case of external control (J02 is 0 or 1), please turn the
driving signal OFF from outside. In case of panel control
(J02 is 2 or 3), please press the “STOP” key.
While controller is driving, this operating method cannot be
used.
②
Display the frequency by pressing the “DATA” key.
③
When the “STOP” key is pressed, the digit (1
st
digit) at
the left end blinks. This blinking part is a changed digit.
④
Every one press of the “STOP” key moves one digit each
to right direction.
⑤
If the “STOP” key is pressed at the right end (4
th
digit), it
turns to normal frequency display of all digits.
⑥
If the “UP” or the “DOWN” key is pressed at blinking
position, frequency data of applicable digits can be
changed.
⑦
If the “FUNC” key is pressed during change of frequency,
it returns to display of the stopped condition. If the
condition without any operation continues for 20 seconds,
it automatically returns to display of the stopped
condition. In such an event, if data was being changed,
the changed data is reflected.
⑧
Usage of the frequency fast-forward operation is also
possible for frequency H12, H14 and H16 of function by
the same manner. But, it is limited only at the time when
the controller is under stopped condition.
ＤＡＴＡ
ＥＮＴＥＲ
DATA
ENTER
STOP
STOP
Halt condition
(0V blinks)
Frequency
※
Up-and-down of digit can be done
automatically. But, in case that it is outside the
adjustment range, the up-and-down of digit is
not possible.
