OnTime Clock
Installation and User Guide
Firmware Version 1
All claims based on information publicly available at time of printing. All other product or service names mentioned
in this document may be trademarks of the companies with which they are associated.
© 2015 Novanex, Inc. | All rights reserved | page 12
4.8. Cantilever Mounting the Digital Clock
– Single or Double
The following is a recommended procedure for cantilever mounting. This procedure
requires a mounting kit (either ONT4KIT or ONT6KIT).
Figure 8: Digital Clock Cantilever Mounting
1.
Determine the clock mounting location.
2.
Using the template provided, mark the location where the clock is to be
mounted, making sure the center is located over the data cable outlet.
3.
Join the Ethernet Clock Mount and the Ethernet Clock Cantilever Wall Mount
using a #2 Phillips screwdriver and a
3
/
8
” wrench.
Make sure that the two
washers are fitted between the Clock Mount and the Cantilever Wall Mount.
Refer to Figure 9.
Figure 9: Digital Clock Mounting Kits
4.
Insert 10 to 12 inches (30 cm) of data cable through the center hole of the
mounting unit.
5.
Attach the unit to the wall with fasteners suitable for the surface.
6.
Lift the clock into place and insert the data cable into the jack located on the back
of the clock.
7.
Position the keyhole slots located on the rear of the clock over the mounting tabs
on the clock mount.
8.
Pull the clock slightly downwards until the unit is seated securely.
9.
Repeat for the second clock if clocks are being installed back-to-back.
