Chapter 3: Tuning and Testing Procedures
© 2019 Cutting Edge Optronics
36
Patara II and Iklwa II Service Manual
7.
Inspect the new optic using a microscope for cleanliness and damage. Clean
as required.
8.
Apply 2216 epoxy to the mount as shown in
Figure 2-29
.
Figure 2-29: Location of 2216 on Mount
9.
Place optic into mount and bond at the locations as shown in
Figure 2-31
below. Use #8-32 screw and .002 shims (red) to secure and center optic. Be
sure that the assembly remains flat until the 2216 is cured.
10.
Cure at 66°C for 2 hours, or for a minimum of 12 hours at room temperature.
11.
Remove #8-32 screw and shims. See
Figure 2-30
for how it should look.
Figure 2-30: Location of 2216 on Optic
12.
Orient steering mirrors according to
Figure 2-31
.
