Nortel Millennium multi-pay M1211, Инструкция по установке, эксплуатации и обслуживанию

Страница: 114 / 350

Operation codes interface 4-5
4. Enter operation codes.
• Each code that you enter during the session dis­
plays on the VFD.
• If an operation code has only one or two digits,
do not enter leading zeros.
• If you make a mistake, press ♦ and re-enter the
code.
5. When the operation code is correct, press * .
After you save each operation code for the session,
up to the eighth code, the code just entered disap­
pears from the display, and the rest of the prompt
remains unchanged.
6. To end the session after entering eight or fewer opera­
tion codes, do one of the following:
• Press the # (STOP) after keying in the final code.
This action saves the final operation code.
• Press * (SAVE) and then # (STOP).
The terminal returns to the idle state.
7. If you need to enter an eighth operation code, enter it
and press * .
• After saving the eighth code in a single session,
a message appears on the VFD saying you have
entered the maximum of eight codes and the
session is ending.
• The message remains on display for 4.5 sec­
onds, then the terminal returns to the idle state.
• If you want to enter more operation codes, you
need to initiate a new session.
If you try to enter more than eight operation codes in a single
session,
this message
appears
on the VFD:
Last code not saved
Maximum of 8 codes
Millennium multi-pay terminal installation, operation, and maintenance guide