Nortel 703t, Техническое обслуживание и диагностика

Страница: 159 / 248

January 2007 Replacing media drives
703t Server Maintenance and Diagnostics 159
7 Place the drive in an antistatic protective wrapper.
8 Continue with “”To install a replacement tape drive”” below.
To install a replacement tape drive
1 Remove the new tape drive from its protective wrapper, and place it
on an antistatic surface.
2 Record the drive model and serial numbers in your equipment log.
3 Set the settings of the tape drive as described in “Tape drive
configuration” on page 156.
For instructions on changing the tape drive’s settings, refer to the
drive manufacturer’s documentation.
4 Attach the slide rails to the replacement tape drive with the screws
you removed earlier.
5 Slide the tape drive into the tape drive bay.
6 Secure the tape drive to the front of the server with the screws you
removed earlier.
Tighten the screws firmly.
7 Refer to the “Cabling diagram” on page 146, and then connect the
tape drive’s SCSI cable as follows:
a. Connect one end of the SCSI cable to LVD (the wide SCSI
controller of the server) on the server’s motherboard.
b. If a terminator is not attached to the cable, attach a wide SCSI
terminator to the other end of the SCSI cable.
c. Connect the second connector on the SCSI cable to the tape
drive.
d. For proper cooling and air flow, neatly fold and secure the
excess signal cable into the last bay (at the bottom of the