Nortel 703t, Техническое обслуживание и диагностика

Страница: 153 / 248

January 2007 Replacing media drives
703t Server Maintenance and Diagnostics 153
To install the hard drive
1 Slide the hard drive and drive carrier assembly (with the exposed
drive facing up) into the server bay.
2 If not already done: Temporarily remove the front system fans from
their slots in the bottom fan holder foam.
Do not disconnect the fans’ power cables.
3 Connect the hard drive SCSI cable as follows (the end of the cable
with two connectors is the hard drive end):
a. Ensure that a terminator is connected to the last connector at
the hard drive end of the cable.
b. Connect the second connector on the cable to the hard drive.
Place one hand on the front of the hard drive to hold it in place
while you connect the cable with the other hand.
c. Route the cable above the CPU through the vacant space at
the top of the server.
ATTENTION
The last bay must remain empty to ensure proper system
cooling.
ATTENTION
To provide more space inside the server so that you
can connect the cables,
do not push the drive all the
way in (that is, until it clicks into place).
.
CAUTION
Risk of connector pin damage
To prevent damage to the connector pins, ensure that
the cable connector aligns correctly with the hard drive
connector before pushing it into place.