Nortel 1000E PRI, Руководство по установке и пусконаладке

Страница: 85 / 162

Configure E1/T1 ports on a Call Server 85
•
CE-MUX clock controllers
•
PRI, PRI2, and DPNSS/DASS routes
•
PRI, PRI2, and DPNSS/DASS trunks
PRI digital trunk loop configuration
Procedure 16 “Configuring PRI loops using LD 17” (page 85) describes
the configuration in LD 17 to support PRI/T1 loops (common equipment
parameters) on the PRI Gateway.
Procedure 16
Configuring PRI loops using LD 17
Step Action
1 Log on to the CS 1000E.
2 To access LD 17, enter:
LD 17
3 Enter the responses shown in Table 16 "PRI loop configuration
(LD 17)" (page 85) .
ATTENTION
VDC configuration is not required for DASS signaling.
Table 16
PRI loop configuration (LD 17)
Prompt Response Description
REQ CHG Change existing data.
TYPE CEQU Make changes to common equipment parameters.
CFN YES Common equipment.
...
DLOP loop dd ff Digital loop (1.5 Mb)
The format is: loop is 0–254, dd is 0-24 (maximum
simultaneous calls) and ff is D2, D3, D4, or ESF.
Enter X to delete the loop.
MG_CARD supl sh card The physical card for the digital loop association to the
PRI Gateway is required.
The format is: superloop, shelf num, card num. For the
PRI Gateway, card 1-8 is applicable.
MODE PRI Mode of operation.
TMDI NO TMDI functionality is not supported for MGP gateway.
... ...
Nortel Communication Server 1000
Media Gateway 1000E PRI Gateway Installation and Commissioning
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
.