Nortel 1000E PRI, Руководство по установке и пусконаладке

Страница: 106 / 162

106 Configure an E1/T1 card
Step Action
1 In LD 60, enter the command to enable the system clock
controller on the specific superloop and shelf:
ENI CC 1 s
2 Enter the command to enable clock tracking on the Gateway
specified by the superloop and shelf tracking to primary,
secondary or free run:
TRCK aaa 1 s
where aaa is:
•
PCK for the primary track clock
•
SCLK is the track secondary clock
•
FRUN is the free run mode
3 To check the status of the system clock on the specified
superloop and shelf, enter the command:
SSCK 1 s
--End--
Initial configuration of the E1/T1 card
Configure basic parameters through command line interface
Follow Procedure 36 “Configuring basic parameters through CLI” (page
106) to configure the basic parameters.
Procedure 36
Configuring basic parameters through CLI
Step Action
1 Connect to the CLI through RS-232. Make sure the CLI screen is
active.
ATTENTION
The E1/T1 card ignores all RS-232 control signals, so a modem
eliminator (null modem) is required as shown in
Figure 25 "Modem
connection" (page 113) .
2 Power up the system.
3 Enter the LAN settings. For detailed information, see “Configure
LAN parameters” (page 108) .
Nortel Communication Server 1000
Media Gateway 1000E PRI Gateway Installation and Commissioning
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
.