Nordson Tribomatic 2, Руководство пользователя по изделию

Страница: 14 / 73

Safety
1-8
E 1995 Nordson Corporation
All rights reserved
Issued 11/95
A1EN − 03 − [SF − POWD] − 4
S
Disconnect, lock out, and tag electrical power at a disconnect or
breaker in the service line ahead of electrical equipment before
servicing.
S
Do not attempt to service electrical equipment if there is standing
water present. Do not service electrical equipment in a high-humidity
environment.
S
Use tools with insulated handles when working with electrical
equipment.
S
Do not attempt to service a moving piece of equipment. Shut off the
equipment and lock out power. Secure equipment to prevent
uncontrolled movement.
S
Relieve air pressures before servicing equipment. Follow the specific
instructions in this manual.
S
Make sure that the room where you are working is sufficiently
ventilated.
S
If a “power on” test is required, perform the test carefully and then
shut off and lock out power as soon as the test is over.
S
Connect all disconnected equipment ground cables and wires after
servicing the equipment. Ground all conductive equipment.
S
Service lines connected to panel disconnect switches may still be
energized unless they are disconnected. Make sure the power is off
before servicing. Wait 5 minutes for capacitors to discharge after
shutting off the electrical power.
S
Turn off the electrostatic power supply and ground the gun electrode
before adjusting or cleaning.
S
Keep high-voltage connection points clean and insulated with
dielectric grease or oil.
S
Check all ground connections periodically with a standard ohmmeter.
Resistance to ground must not exceed one megohm. If arcing
occurs, shut down the system immediately.
9. Maintenance and Repair
(contd.)