Nordson Tribomatic 2, Руководство пользователя по изделию

Страница: 27 / 73

Installation
3-1
E 1998 Nordson Corporation
All rights reserved
303 815A
Issued 3/98
Manual 37-32
Section 3
Installation
WARNING: Allow only qualified personnel to perform the
following tasks. Observe and follow the safety instructions in
this document and all other related documentation.
1. See Figure 3-1. Install the gun mounting bar (2) on a fixed gun stand
or gun mover arm (1).
2. Unscrew the adjuster (4) from the ball mount cap (7). Slide it over the
end of the mounting bar (3).
3. Loosen the two set screws (6) in the ball mount flange (5). Slide the
end of the mounting bar into the flange. Tighten the set screws.
4. Slide the adjuster down the mounting bar. Thread it onto the ball
mount cap.
5. Make sure the M6 x 8 set screw (8) is tightened.
6. Rotate the gun to the desired position, then tighten the adjuster to
lock the gun into position.
1. Mounting