Nordson Tribomatic 2, Руководство пользователя по изделию

Страница: 47 / 73

Repair
6-7
E 1998 Nordson Corporation
All rights reserved
303 815A
Issued 3/98
Manual 37-32
1. See Figure 6-7. Slide the new positioning ring (3) onto one end of the
new inner wear sleeve (4).
NOTE: The spacing and positioning rings, as well as the inner and outer
wear sleeves, are reversible.
2. Screw the inlet distributor (1) onto one end of the threaded rod (2).
Insert the threaded rod into the positioning ring end of the inner wear
sleeve. Screw the outlet distributor (5) onto the threaded rod and
tighten it securely by hand.
3720014A
1
2
3
4
5
Fig. 6-7 Inner wear sleeve assembly
1. Inlet distributor
2. Threaded rod 3. Positioning ring
4. Inner wear sleeve 5. Outlet distributor
3. See Figure 6-8. Push the inner wear sleeve assembly (1) into the
outer wear sleeve (3) until the positioning ring (2) seats properly into
the outer wear sleeve.
4. Install the new spacing ring (4) over the inner wear sleeve assembly.
Seat it in the end of the outer wear sleeve.
3720024A
2
1
3
4
Fig. 6-8 Installing the inner wear sleeve into the outer wear sleeve
1. Inner wear sleeve assembly
2. Positioning ring 3. Outer wear sleeve 4. Spacing ring
Installation