Nordson Tribomatic 2, Руководство пользователя по изделию

Страница: 44 / 73

Repair
6-4
E 1998 Nordson Corporation
All rights reserved
303 815A
Issued 3/98
Manual 37-32
1. See Figure 6-3. Install the O-rings (3, 5) on the inlet wear sleeve (4).
2. Install the spring (9) and O-rings (8) on the outlet wear sleeve (10).
3. See Figure 6-4. Insert the inlet wear sleeve assembly (1) into the
body (3).
4. Insert the outlet wear sleeve assembly (2) into the extension (4).
3720011B
3
1
2
4
Fig. 6-4 Installing the inlet and outlet wear sleeve assemblies
1. Inlet wear sleeve assembly
2. Outlet wear sleeve assembly 3. Body 4. Extension
5. See Figure 6-5. Insert the inner and outer wear sleeve assembly (2)
into the body (1) with the inlet distributor (cone-shaped end) first.
Make sure the positioning ring (3) fits into the groove in the ID of the
inlet wear sleeve.
6. Make sure the spacing ring (4) is in place in the end of the outer wear
sleeve. Slide the extension (5) over the inner and outer wear sleeve
assembly. Engage the slots in the extension with the pins in the body.
Push the extension in and rotate it clockwise to lock it to the body.
7. Install the sprayhead and diffuser. Connect the powder feed tubing
and diffuser air line.
Installation