Nordson Spectrum II S2-900 C Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 262

1-10 Introduction
1.10.23 Programmable Tilt and Rotate
The Programmable Tilt and Rotate (PTR) option provides fully automated valve tilting in both the X and
Y-axis, with an integrated rotation function in the motorized tilt arm for systems configured with the
IntelliJet, DJ-9000, or DJ-9500 dispensing valve. The PTR bracket mounts on the dispensing head in
place of the standard dovetail mount. Fluids can be dispensed with the valve tilted at angles of up to 30
degrees from vertical in the front-to-rear and/or left-to-right directions. This allows the dispensing of
fluids around tall components and into vertical corners. In addition, the nozzle tip can be closer to the
target location for precise fluid delivery.
Programmable rotate and tilt angles are assigned to individual dispense instructions. Up to ten (10)
programmable tilt angle and dispense gap combinations are available for each program.
1.10.24 SECS/GEM Interface
The SECS/GEM Interface allows the Fluidmove software to communicate via Ethernet with factory
management software running on a host computer connected to the network.
1.10.25 Service Station
The Service Station consists of:
•
Dispense tile: A ceramic tile dispensed upon during system offset routines.
•
Tactile needle sensor: Measures the offset between the needle/nozzle and the height sensor.
• Purge station: Small reservoir that contains a disposable plastic cup (#6 Plastic Polystyrene
material) and is attached to a vacuum generator. Air flowing through the purge boot into the
cup removes excess fluid on the dispensing valve needle/nozzle.
•
Scale: Measures the weight of dispensed fluid and sends the information to the Fluidmove
software for Mass Flow Calibration (needle dispensing) or Calibrated Process Jetting (jet
dispensing). The scale is standard on the S2-900P dispensing system and an option on the
S2-900 dispensing systems.
1.10.26 Single-Axis Automatic Tilt
The Single-Axis Automatic Tilt option provides angled jetting for increased dispensing flexibility. Single-
axis tilt is configurable (in X or Y direction) and saved within the Fluidmove recipe.
1.10.27 Ventilation Exhaust System
The Ventilation Exhaust System works in conjunction with the facility exhaust system to remove excess
heat, fumes, or odors into an exhaust vent. The exhaust system can be configured as either down or
updraft and can remove fumes that are lighter and/or heavier than air. The system baffles direct vapor and
mist to a spill pan and routes exhaust through a plenum out the exhaust duct.