2
PART NUMBERS COVERED BY THIS MANUAL
This manual covers the set up and use of Norbar ProTronic
®
Standard Tools.
Part Number
Description
Torque Measurement
(N·m)
130517
ProTronic
®
Model 100
⅜
” sq. dr.
5 - 100
130518
ProTronic
®
Model 100 ½” sq. dr.
5 – 100
130519
ProTronic
®
Model 200 ½” sq. dr.
10 - 200
130520
ProTronic
®
Model 340 ½” sq. dr.
17 - 340
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
RISK OF FLYING PARTICLES
OVER-TORQUING CAN CAUSE BREAKAGE. AN OUT OF CALIBRATION
ANGLE WRENCH CAN CAUSE PART OR TOOL BREAKAGE. BROKEN
HAND TOOLS, SOCKETS OR ACCESSORIES CAN CAUSE INJURY.
EXCESS FORCE CAN CAUSE CROWFOOT OR FLARE END FITTING
SLIPPAGE.
•
Read
this manual completely
before using ELECTRONIC WRENCH.
•
To ensure accuracy, work must not move in angle mode.
•
For personal safety, and to avoid wrench damage, follow good professional tool
and fastener installation practices.
•
Periodic recalibration is necessary to maintain accuracy.
•
Wear safety goggles, user and bystanders.
•
Be sure all components, including all adaptors, extensions, drivers and sockets
are rated to match or exceed torque being applied.
•
Observe all equipment, system and manufacturer's warnings, cautions and procedures when using this
wrench.
•
Use correct size socket for fastener.
•
Do not use sockets showing wear or cracks.
•
Replace fasteners with rounded corners.
•
To avoid damaging wrench:
Never use wrench with power off. Always turn ON wrench so applied
torque is being measured.
•
Do not press
POWER
while torque is applied or while wrench is in motion.
•
Never use this wrench to break fasteners loose.
•
Do not use extensions, such as a pipe, on handle of wrench.
•
Check that wrench capacity matches or exceeds each application before proceeding.
•
Verify calibration if dropped.
•
Verify calibration of wrench if you know or suspect its capacity has been exceeded.
