23
•
Cables labeled with
UP
go on the same side
as the hydraulic hoses on the
44963D
block.
44933D
44963D
Figure 25 – Valve Cable Connections
13.
Connect the CAN Node cable (
C02B
) to the
4-pin AMP plug on
C11
(
Figure 26
).
14.
Route the CAN Node cable (
C02B
) to the
roll sensors which are installed in
Section
4.5
. Follow existing cables and/or hydraulic
lines.
15.
Connect 4-pin AMP connectors on
C02B
to
the sensors.
16.
Connect the sensor branch cable (
C02
) to the
4-pin AMP plug on
C02B
.
17.
Route the sensor branch cable (
C02
) to the
wing and main sensors and connect to the
sensors. Follow existing cables and/or
hydraulic lines along the boom.
18.
Cable-tie the installed cables every 12 inches.
IMPORTANT:
Provide enough slack in all cables to account
for the movement of the main section, parallel
lift, and FOLDING boom movement.
Figure 26 – Cable Configurations: C11, C02
and C02B
Содержание UC4+ Raptor Pro 1200
