17
4.6
H
YDRAULIC
I
NSTALLATION
WARNING!
The hydraulic system creates very high
pressure. Before disconnecting any hydraulic
lines ensure all pressure has been bled from
the system. When changing the boom
hydraulic
hoses
leave
the
booms
in
TRANSPORT POSITION.
IMPORTANT:
Component failure due to oil contamination is
not covered under the UC4+ Spray Height
Control system warranty. It is recommended
that a qualified technician does the hydraulic
installation.
Depending on the valve block part number,
the A and B ports may be reversed. Ensure
that the orifices are oriented properly for the
A and B ports or the system will not function
properly.
4.6.1 Valve Assembly
1.
On a clean surface remove all plastic plugs
from the NORAC hydraulic Valve (
V01
)
(
Figure 18
).
44963D
44933D
Figure 18 – NORAC Valve Block
2.
Install the 6MB-6MOR (
F04
) fittings on the
“P” and “T” ports and tighten to 18 ft-lbs.
3.
Install the orifices (
F06
) into the “B” ports
with
the notch facing outward
as shown in
Figure 19
. An O-ring pick can be used to
ease installing the orifices into their
locations.
4.
Install the 6MB-6MOR fittings (
F04
) into the
“B” ports and tighten to 18 ft-lbs.
5.
Install the 6MBP plugs (
F02
) into the “A”
ports and tighten to 18 ft-lbs.
44963D
Содержание UC4+ Raptor Pro 1200
