21
Figure 23 – Cable Configurations: C01, C04 and C10
2.
Connect the UC4+ power cable (
C10
) to
the UC4+ Control Panel in the sprayer
cab.
Ensure the UC4+ control panel’s
power is OFF for the remaining
installation (Bottom of switch
pressed IN). Use caution when
handling the 12 V power line of the
existing wiring.
3.
Connect the 3-pin AMP plug on
C10
to
the mating receptacle in the sprayer
console on the left side of the cab. This
connection will supply battery power to
the UC4+ system.
4.
Connect the 6-pin Tower on
C10
to the
valve extension cable (
C04
)
The valve extension cable (C04)
may be packaged with one GP end
not installed. This is normal; it
helps
installations
for
other
sprayer types. Pin this connector
on (connector included) as per
drawing in Section 5.5. TAKE
EXTRA CARE! These pins
require a special tool to remove
them if you make an error!
5.
Connect the sensor trunk cable (
C01
) to
the UC4+ Control Panel
6.
Route
C01
and
C04
to the rear of the
sprayer, somewhere near the NORAC
hydraulic valve block.
Содержание UC4+ Raptor Pro 1200
