Nomadix AG 2300, Руководство пользователя, Страница: 51 / 294

A
CCESS
G
ATEWAY
Installing the Access Gateway 39
Start Here
1.
Unpack the Nomadix Access Gateway and place the product on a flat and stable work surface.
2. Register the gateway for support services by completing and returning the Nomadix Gateway
Registration Form; hardcopy enclosed or obtain the form online at
http://www.nomadix.com/registration .
3.
Connect the power cord.
4.
Connect to the Access Gateway (AG). There are two ways to connect to the Access Gateway
(AG):
 Serial Connection:
Connect the RJ45 console cable to the product’s console port and the DB9 female to your computer.
Start a HyperTerminal (or equivalent) session to communicate with the AG via the product’s console
interface. Use the following configuration settings for your session:
Bits per Second Data Bits Parity Stop Bits Flow Control
9600 8 None 1 None

Subscriber-side Ethernet Connection:
Connect an Ethernet cable between the product’s Eth1 port and your computer’s Ethernet port.
5.
Setup a SSH client to establish a SSH session to communicate with the NSE gateway via the
administrative IP address after the Access Gateway finishes powering up. The administrative IP
address is 172.30.30.172.
IP Address 172.30.30.173
Netmask 255.255.0.0
Gateway 172.30.30.172
DNS (If Required) 4.2.2.1
6. Turn on the product. You can then configure the WAN for a static IP address, DHCP Client or PPPoE client
using appropriate configuration guidelines that follow in order to obtain the license key. Once the key has
been obtained, the web management interface (WMI) can be used to continue configuration.
LCD Messages
Some Access Gateway hardware models are equipped with an LCD panel, that displays the following system
information:

Platform and Firmware Version Installed

Primary IP Address of the NSE

NSE ID

Active Subscribers.