Nivus OCM PRO CF, Инструкция по эксплуатации

Страница: 65 / 194

Instruction manual
OCM Pro CF
®
OCM Pro CF - Rev. 09 as of 07.06.2016 page 65
8 Initial Start-Up
8.1 General
Notes to the user
Before you connect and operate the OCM Pro CF you should strictly follow the
notes below!
This instruction manual contains all necessary information to program and to
operate the device, addressing qualified technical staff who have appropriate
knowledge about measurement technology, automation technology, information
technology and waste water hydraulics.
To ensure a correct function of the OCM Pro CF this instruction manual must be
read thoroughly!
The OCM Pro CF must be wired in accordance with the wiring diagram, see
chapter 7!
If any problems regarding installation, connection or programming should occur
please contact our hotline
+49 (0)7262 9191-955.
General Principles
The initial start-up is not allowed until the installation has been finished and
checked.
To exclude faulty programming this instruction manual must be read before the
initial start-up.
Please get familiar with the OCM Pro CF programming via display and keyboard
by reading the instruction manual before you begin to program the device.
After transmitter and sensors are connected (see chapters 7.2.3 and 7.3.3) the
parameters must be set. In the most cases all you need is:
-
geometry of the measurement place and dimensions
-
used sensors and positioning
-
display units
-
span and function of analog and digital outputs
The OCM Pro CF user surface has been designed in a way which allows even
unfamiliar users to easily set up basic settings in graphic dialog mode ensuring
reliable device operation.
Either let the manufacturer or an expert company authorised by the manufactur-
er do programming works as soon as the following requirements are prevailing:
-
extensive programming
-
difficult hydraulic conditions
-
special channel shapes
-
lack of expert personnel
-
if a setup and error protocol is required