Nivus OCM PRO CF, Инструкция по эксплуатации

Страница: 16 / 194

Instruction manual
OCM Pro CF
page 16 OCM Pro CF - Rev. 09 as of 07.06.2016
®
3.2 Intended Use
Important Note
The device is exclusively intended to be used for purposes as described
below.
Modifying or using the devices for other purposes without the written consent
of the manufacturer will not be considered as use in accordance with the re-
quirements.
Damages resulting from this are left at user’s risk.
The device is designed for a lifetime of approx. 10 years. After that period an
inspection in addition with a general overhaul must be carried out.
The measurement device type OCM Pro CF including the respective sensor
technology supplied by NIVUS is intended to be used for continuous flow meas-
urement of slight to heavy polluted media in part filled and full channels, pipes or
similar. Here the allowed maximum values, as specified in chapter 0, must be
strictly kept. All cases which vary from these conditions and are not approved by
NIVUS GmbH in written form are left at owner’s risk.
Important Note
Install the device outside of Ex zones!
The Ex approval of the sensors is part of the „Technical Description for Corre-
lation Sensors“.
Ex-Identification
Transmitter:
II (2)G [Ex ib Gb] IIB
CAUTION
Damages invalidate the Ex protection
Damage might invalidate the Ex protection.
The OCM Pro CF then is not allowed to be used in Ex area any longer.
Protect the OCM Pro CF from shocks, drops or other damage.
Note
The approval is only valid in connection with the respective indication on the
device nameplate.
The Ex-version of OCM Pro CF is matched to the NIVUS sensors regarding
the assessment of intrinsically safe electrical systems according to
EN 60079-25.
In case of using sensors from third party manufacturers the operator must
carry out a system review according to EN 60079-25!
The required specifications of the OCM Pro CF Ex version can be taken from
the EC-type examination certificate TÜV 00 ATEX 1572.