ENGLISH / A-35
FORM NO. 56041980 - CS7000 -
A-35
HOPPER DUST CONTROL FILTER
The hopper dust control
fi
lter must be cleaned regularly to maintain the ef
fi
ciency of the vacuum system. Follow the recommended
fi
lter service
intervals for the longest
fi
lter life.
CAUTION!
Use only the approved Nil
fi
sk high capacity dust control
fi
lter in this machine. Use of standard pleated
fi
lters will result in insuf
fi
cient
air
fl
ow, inadequate clean shaking, and potential machine damage.
Wear safety glasses when cleaning the
fi
lter.
Do not puncture the paper
fi
lter.
Clean the
fi
lter in a well-ventilated area.
To remove the hopper dust control fi lter...
1
See Figure 16.
Unlatch the Hopper Cover Latches
(16)
and lift the Hopper Cover.
2
Loosen the two Thumb Nuts
(HA)
, then slide the Filter Shaker Motor Assembly
(HB)
to the left and lift it out of the hopper.
3
Hang the shaker assembly on the hopper cover Hinge Hook
(HC)
.
4
Inspect the top of the Hopper Dust
Control Filter
(17)
for damage. A
large amount of dust on top of the
fi
lter is usually caused by a hole in
the
fi
lter or a damaged
fi
lter gasket.
5
Lift the Hopper Dust Control Filter
(17)
out of the machine.
6 Clean
the
fi lter using one of the
methods below:
Method
“A”
Vacuum loose dust from the
fi
lter.
Then
gently
tap the
fi
lter against
a
fl
at surface (with the dirty side
down) to remove loose dust and dirt.
NOTE:
Take care not to damage the
gasket.
Method
“B”
Vacuum loose dust from the
fi
lter. Then blow compressed air
(maximum pressure 100 psi) into
the clean side of the
fi
lter (in the
opposite direction of the air
fl
ow).
Method
“C”
Vacuum loose dust from the
fi
lter.
Rinse the
fi
lter under a gentle stream
of water (maximum pressure 40 psi).
Let the
fi
lter dry
completely
before
putting it back into the machine. It is
recommended to have a spare
fi
lter
on hand to use while the washed
fi
lter is drying out.
7
Keep Ledge
(HD)
clean of any dust
or debris, this is where the
fi
lter
gasket contacts the hopper.
8
Follow the instructions in reverse
order to install the
fi
lter. If the gasket
on the
fi
lter is torn or missing, it must
be replaced.
NOTE:
Be sure to
reinstall so that the air
fl
ow decal is
pointing up as shown.
FIGURE 16
Содержание 56509003
