English –
8
EN
3.7 - Climatic sensors
3.7.1 - SETTING THE INTERVENTION LEVEL FOR “WIND” PROTECTION
01.
Press the button
ON
: the current setting will appear on the level LEDs.
If no “wind” protection, has been set, the level LEDs flash simultaneously.
02.
Use the
or
button to turn on the LED that corresponds to the desired
setting.
03.
➔
The
green OK
LED flashes: (within 3 sec) press the
OK
button to confirm.
Note:
The number of levels available depends on the type of motor connected and the
maximum and minimum values of this motor.
3.7.2 - ENABLING/DISABLING OF CLIMATIC SENSORS
This button allows you to enable/disable the intervention of the SUN and RAIN sensors.
If the function is active, the corresponding LED will be lit, otherwise off.
01.
Press the button
ON
to activate/deactivate the SUN and RAIN sensors: the cor-
responding LED starts flashing.
02.
➔
The
green OK
LED flashes: (within 3 sec) press the
OK
button to confirm.
3.6.5 - SETTING THE LEVEL OF SENSITIVITY TO OBSTACLE / DRC
01.
Press the button
RDC
: the current setting will appear on the level LEDs.
02.
Use the
or
button to turn on the LED that corresponds to the desired
setting.
03.
➔
The
green OK
LED flashes: (within 3 sec) press the
OK
button to confirm.
Note:
the number of
levels available depends
on the type of motor
connected.
Examples of levels available for ERA INN
Level LEDs
Level
1
LEVEL 1
2
LEVEL 2
3
LEVEL 3
4
LEVEL 4
5
LEVEL 5
6
LEVEL 6
7
LEVEL 7
8
LEVEL 8
3.6.3 - SETTING THE SPEED
01.
Press the button
RDC
: the current setting will appear on the level LEDs.
If a speed value has been set with procedure 3.6.2, the LEDs flash to indicate
the approximate closest value.
02.
Use the button
or
, until to turn on the LED that corresponds to the
desired setting.
03.
➔
The
green OK
LED flashes: (within 3 sec) press the
OK
button to confirm.
Note:
the number of
levels available depends
on the type of motor
connected and its
maximum and minimum
speed values.
Examples of levels available for ERA INN
Level LEDs
Speed (RPM)
1
6
2
12
3
20
4
26
5
32
6
40
7
48
8
56
3.6.4 - SETTING THE LEVEL “SOFT-START” AND “SOFT-STOP”
01.
Press the button
RDC
: the current setting will appear on the level LEDs.
02.
Use the
or
button to turn on the LED that corresponds to the desired
setting.
03.
➔
The
green OK
LED flashes: (within 3 sec) press the
OK
button to confirm.
Note:
the number of
levels available depends
on the type of motor
connected.
Examples of levels available for ERA INN
Level LEDs
Rpm acceleration/deceleration
1
0.0
2
0.7
3
1.5
4
2.0
5
2.5
6
3.0
7
3.5
8
4.0
