English –
2
EN
PRODUCT OPERATION
3
• Switching On of TTPRO BD:
press and release the
ON/OFF
button. If it is connected to a
motor/control unit, it immediately displays the functions already programmed and those available.
• Switching Off of TTPRO BD:
hold the
ON/OFF
button for a few seconds until it beeps.
If not used, it switches off automatically after 1 minute.
3.1 - Function and description of buttons
BUTTON FUNCTION
DESCRIPTION
OK
OK
Confirms each programming activity.
ON/OFF
Switching on/off of TTPRO BD and search for con-
nected motor.
OPEN
Sending of Open command
(= Open button on the transmitter).
STOP
Sending of Stop command
(= Stop button on the transmitter).
CLOSE
Sending of Close command or, for the awnings, De-
scent command (= Close button on the transmitter).
DA
Y
CONT
.
AUTO
1
2
Test / Mode / V
alue Set
3
4
5
6
7
8 A
ON
F2
F1
F3
RADIO
TEST
Chrg
ON
RDC
Usb
1
PRODUCT DESCRIPTION AND INTENDED USE
1
The TTPRO BD programmer is a logical unit designed to simplify the installation, testing
and maintenance of Nice motors and control units. It is compatible with motors/control
units of the ERA/ERA INN series.
WARNING! - Any other use different from that described and in ambient condi-
tions different from those provided in this manual is to be considered improper
and prohibited!
TTPRO BD communicates with the motor/controller via the TTBUS (with its dedicated ca-
ble) or RADIO BD (if the motor/controller are enabled to do so). Nice’s new two-way radio
protocol enables communication in both directions between the transmitter and receiver,
as does the mesh network which can connect to any Nice automation within radio range.
The transmitter signal confirms that the control has been received correctly and allows the
position of the automation to be controlled at all times. Wireless technology makes even
initial programming simple and user-friendly.
TTPRO BD allows you to quickly and intuitively perform the procedures normally per-
formed with the transmitter. It acts directly on the motor/control unit, where the transmit-
ters and the operation parameters are stored.
Other functions are available:
- ability to read the configuration of a motor/control unit (parameters and/or transmitters)
and to transfer the configuration to one or more motors/control units.
- ability to copy and transfer the configuration of a group of motors, if these are connected
to the control panel via TTBUS network or by RADIO BD.
Components and accessories in the package:
• 1 programmer TTPRO BD
• 1 connection cable to the motor
• 1 micro-USB connection cable
• 2 rechargeable Ni-MH AA batteries
ELECTRICAL CONNECTIONS
2
WARNING!
- The motor/control unit should only be powered as described in the respective
instruction manual.
- TTPRO BD must be connected to a single motor/control unit. If you want to con-
nect multiple motors, it is necessary that each motor is associated with a differ-
ent address to those used by other motors. It is therefore essential that, before
you connect them all, you use TTPRO BD (connected in TTBUS mode with the
dedicated cable) to assign a unique address to each motor/controller..
Normally, TTPRO BD works with 2 rechargeable batteries, however, if necessary, it can also
be powered with the included USB cable.
To use TTPRO BD with the TTBUS connection to the motor/controller, you must use the
included cable with the correct polarity (
fig. 1
):
-
white-black cable
(COMMON - 0 V) to be connected to the
black wire
of TTPRO BD
-
white cable
(STEP-BY-STEP + TTBUS) to be connected to the
white wire
of TTPRO BD
