Nice DPRO500, Инструкции и предупреждения по установке и использованию

Страница: 8 / 104

4
– English
EN
TABLE 1 - Technical specifications of electrical cables
Connection Cable type Maximum admissible length
CONTROL UNIT POWER SUPPLY Cable
- three-phase
- single-phase
4 x 1 mm
2
3 x 0,75 mm
2
5 m ( note 1 )
2 m ( note 1 )
MOTOR cable special cables for Nice gearmotors are on sale as
accessories.
for other brands, contact the motor manufacturer
5 - 7 - 11 m
Cable for FLASHING LIGHT with aerial 2 x 1 mm
2
(for 230 V AC flashing light)
RG58 type shielded cable (aerial)
10 m
PHOTOCELL cable 4 x 0,5 mm
2
10 m
KEY SWITCH cable 2 cables 2 x 0.25 mm 2 10 m (
note 2
)
SPIRAL cable for safety edge Nice spiral cable is available as an accessory 50 m
Note 1 – If the power cable exceeds the maximum allowed length, a cable with larger cross-section must be used
Note 2 – These two cables may be replaced by a single 4 x 0.5 mm
2
cable.
CAUTION! – The cables used must be suited to the type of environment of the installation site.
V
W
U
L1
L2
L3
MOTOR
LINE
PE
LED SAFETY
LED L2 LED L1 OUT
FUSES
ALT
INPUT
SAFE
STOP
LIMIT SWITCH
IBT4N
OXI
ENCODER
PROG
A
LED SAFETY = safety chain LED
LED L2 = OK LED (green)
LED L1 = Warning LED (red)
OUT =
slot for the NDA040 accessory
board for expanding outputs
PROG = DIP switch for programming
ENCODER = electronic limit switch
INPUT =
external inputs
8 - com (+24 V DC common)
9 - open
10 - close
11 - photo (ing1)
ALT =
ALT terminal
SAFE =
only for motors with mechani-
cal limit switches (leave uncon-
nected with motors which have
electronic limit switches)
LIMIT
SWITCH
=
mechanical limit switch
STOP =
STOP terminal used for 8K2
safety edge or OSE
5 - positive (+) safety edge
6 - safety edge signal
7 - negative GND (-)
IBT4N =
IBT4N interface connector (not
supplied)
OXI =
connector for connecting radio
receivers with SM plug (SMXI/
OXI)
= aerial
PE
=
earth connection
LINE =
connector for connecting the
three-phase or single-phase
power line
FUSES =
F1, F2, F3, F4: see Technical
Specifications
MOTOR = motor
(+ com)
(– GND)