99
Required Hardware
Each mounting kit should contain the following:
(1) Lower mounting plate (two round holes)
(1) Upper mounting plate (large rectangular opening)
(2) Caddy® 512 snap-on fixture hangers
(4) Clips and spacers
(8) ¼-20 x 1.5" flat socket cap screws
(4) 4-
40 x 3/8” flat socket cap screws
You will also need:
Small handsaw
Drill
Phillips screwdriver, 5/32" (4mm) hex key, and a 1/16” hex key.
Panel Cutting
Mark and cut a hole in the tile to match the layout dimensions. The camera
center is indicated for your convenience when measuring. It is expedient to simply
use the upper plate for this; the cutout is the same.
Initial Assembly
Use the four small 4-40 screws to attach the lower mounting plate to the
camera.
Figure 2
– Lower plate attached to camera
Содержание T-DAR T1010MT
